Master Chef outdoor Stovetop User Manual download pdf (Page 33)

Because the height of the cooker can be adjusted and

each connection is different it is difficult to give precise

dimensions. Ideally the house supply bayonet should be

in the shaded area shown in the diagram. This hose

should be fitted so that both inlet and outlet connections

are vertical so that the hose hangs downwards in a ‘U’

shape. A 3ft hose will need to be connected from the side.

For Natural Gas the flexible hose must be in accordance

with B.S. 689.

For LP Gas it should be capable of 50mbar pressure,

70ºC temperature rise and carry a red stripe, band or

label.

If in doubt contact, your supplier.

Screw connect the threaded end of the hose into the gas

inlet in the underside of the connector block on the back

of the cooker.

After completing the gas connection, check the cooker is

gas sound with a pressure test. When checking for gas

leaks do not use washing up liquid - this can corrode. Use

a product specifically manufactured for leak detection.

Pressure Testing

The gas pressure can be measured at the fish kettle

burner jet. Make sure that the cooker is not connected to

the electricity supply. Lift off the burner head. Fit the

pressure gauge to the jet. Turn on one of the other burners

and light it with a match. Turn on the control for the fish

kettle burner and press in the knob to allow the gas

through and register the pressure on the gauge.

For Natural gas cookers the pressure should be 20mbar.

For LP gas (propane) the pressure should be 37mbar.

Re-assemble burner top, making sure it is re-assembled

in the correct way on the burner body.

Electrical Connection

This appliance must be installed by a qualified electrician

to comply with the relevant regulations and also the local

electricity supply company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED.

NOTE: The cooker must be connected to the correct

electrical supply as stated on the voltage label on the

cooker, through a suitable cooker control unit

incorporating a double pole switch having a contact

separation of at least 3mm in all poles. This cooker must

not be connected to an ordinary domestic power point.

The total electrical load of the appliance is approximately

8.8 kW. The cable size used should be suitable for this

load and comply with all local requirements.

Access to the mains terminal is gained by removing the

electrical terminal cover box on the back panel.

Connect the mains cable to the correct terminals for your

electrical supply type.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Comments to this Manuals

No comments

Master Chef outdoor Stovetop User Manual Page 33

Comments to this Manuals