Master Chef outdoor Stovetop User Manual download pdf (Page 4)

The drawing above each knob indicates which burner that

knob controls. There is a spark ignition system that works

when the knob is pressed in. Each burner also has a

special safety device that stops the flow of gas if the flame

goes out.

Push in and turn a knob to

the large flame symbol

( ).

Keep holding the knob

pressed in to let the gas

through to the burner for a

few seconds. The igniter will

spark and light the gas

automatically.

If, when you let go of the control knob, the burner goes

out, the safety device has not held in. Turn the control to

the off position and wait one minute, then try again this

time holding in the control

knob for slightly longer.

Adjust the flame height to

suit by turning the knob.

On this cooker the low

position is beyond high, not

between high and off. The

small flame ( ) marks the

‘low position’.

Turn the knob

towards it after the

contents of a pan

have boiled.

Place all pans

centrally over the

burners. The flames

must be on the base

of the pan. Do not allow the flames to go up the sides of

the pan.

Using a lid will help the contents boil more quickly.

Always position pan handles away from the front of the

cooker, out of reach of small children.

Pan and kettles with concave bases or down turned base

rims should not be used.

Simmering aids, such as asbestos or mesh mats, are NOT

recommended. They will reduce burner performance and

could damage the pan supports.

Avoid using unstable and misshapen pans that may tilt

easily and pans with a very small base diameter e.g. milk

pans, single egg poachers.

Minimum pan sizes

The minimum pan diameter recommended is 120mm

(about 4

”).

When the hotplate control knob is pressed in, sparks will

be made at every burner, this is normal.

If, after lighting the hotplate burner flame goes out, turn it

off and leave it for one minute before relighting it.

IMPORTANT: The cast iron pan supports on the

appliance are of a professional design and much

heavier than most if not all gas hob cookers.

Therefore care must be taken when removing or re-

fitting them from or to the hob. It is important that they

are lifted from the appliance. Do not drag them across

adjacent enamelled components as this could

damage the enamel.

You can remove the burner head for cleaning. See the

‘Cleaning your cooker’ section of these instructions

for removal and fitting of the pan supports and burner

parts.

You should wipe the top surface of the cooker around the

hotplate burners as soon as possible after spills occur. Try

to wipe them off while the hotplate is still warm.

Hotplate Burners

1 2 3 4 5 6 7 8 9 ... 43 44

Comments to this Manuals

No comments

Master Chef outdoor Stovetop User Manual Page 4

Comments to this Manuals